C63AMG Dyno & Development

Here are the results from testing and tuning of my C63 AMG.
The car had just over 2000 miles on the clock for the first dyno session. Prior to dynoing, the car has had custom tri-Y long-tube headers and full exhaust fitted.
The car was also previously run at Famoso Raceway, running: header back cat-less X-pipe with Full exhaust & Mufflers + OE Tune + Sunoco 104 gas + Continental Sport stock street tires. 1/4mile – 11.608 @ 121.93
Stock headers and exhaust were re-fitted and the ecu flashed back to factory stock, adaptions were cleared with SDS. The car was then driven for 2 days (approx.70 miles) to re-adapt to the stock tune prior to dyno testing and tuning. For the dyno the car was put into dyno mode and tire pressures checked. The front engine cover removed and hood open during each run. Gasoline used: a full tank from empty of Chevron CA91 Premium.

The first test was to record a baseline pull of absolutely “factory stock” vs. removal of charcoal filters and addition of K&N air filters. The results were surprisingly good, with an additional +10wHp seen (dynograph attached). The factory stock run is green and the run with K&N filters is red.

The second test was to run the car “as is” with K&N filters and charcoals filters removed vs. “Off-the-shelf” ecu tune. +54wHp peak-to-peak gain was seen on top of figures already recorded (attached). The factory stock run is green, the run with K&N filters is red and the tuned run is purple.

The third test was to modify the inside of the stock USDM airbox Ala R.O.W. airbox. (Pictures attached) Gains in low-end Torque were seen on the dyno, peak numbers remaining constant with no further tuning. This run is depicted in Pink on the 3rd dynograph.

NOW AVAILABLE:  Flash Tune your Mercedes Benz via the OBD2 diagnostic port! No more downtime, while sending in your ECU for tuning. Flash your vehicle and switch maps at your convenience…… We are pleased to announce the new release of E-Z Flash flash loaders, now available for Mercedes Benz owners through OE Tuning! More information here: https://oetuning.com/blog/?p=727

One thought on “C63AMG Dyno & Development

Leave a Reply

Your email address will not be published. Required fields are marked *